Front Windshield Wiper Blades (2 Pcs) for BYD ATTO 3 – 24" + 17" Beam Blade Pair

Streaks, smears and that juddering screech across the glass — your ATTO 3's wipers are telling you the rubber has given up. This matched pair puts a clean, silent sweep back on the windscreen in about two minutes per side, with no tools and no guesswork about sizes.

Front wipers are a matched set, not two singles. The ATTO 3 runs a long blade on the driver's side and a shorter one on the passenger side, and this pack contains exactly that combination — a 24-inch blade and a 17-inch blade, both beam-style with the Top-Lock connector the ATTO 3's wiper arms use. Clip them on and the whole swept area of the glass is covered edge to edge, just as the factory set did on day one.

• The sizes are already sorted — 24 in for the driver side, 17 in for the passenger side. That is the ATTO 3's factory pairing (shown on the size diagram in the photos), so both blades arrive correct. No measuring your old blades, no wrong-size returns.
• Beam-blade pressure, end to end — twin spring-steel rails inside each blade flex to the curve of the ATTO 3's windscreen and hold the rubber edge down along its full length. No missed band in the middle of the sweep and no lifted tips at the edges — the two failure modes of worn frame-style blades.
• Aerodynamic spoiler cover — the full-length cover uses airflow at motorway speed to press the blade onto the glass instead of lifting it, so the wipe stays clean and chatter-free when the weather is at its worst.
• Quiet rubber, clean cut — a precision-cut wiping edge glides instead of dragging. The squeak, hop and smear of a hardened old edge are gone from the first sweep.
• Two-minute, tool-free swap — the pre-fitted Top-Lock connector works with a press, a slide and a click (the full sequence is pictured). If you can open a seatbelt buckle, you can change these blades.

• Connector: push-button Top-Lock fitting matched to the ATTO 3 wiper arm — the arm's locking tab engages the adapter's square window and locks with an audible click.
• Blade architecture: frameless beam design with dual internal spring rails (shown in the cross-section photo) for even pressure distribution across curved glass.
• Spoiler: one-piece aerodynamic cover with segmented flex points, so the blade follows the screen's curve without kinking.
• Edge protection: each blade ships with a protective strip over the rubber edge (shown in the last photo). Peel it off after fitting so the wiping edge reaches the glass factory-fresh, untouched by packaging and handling.

• Vehicle: BYD ATTO 3 (also sold as Yuan PLUS)
• Position: front windscreen, driver side + passenger side
• Blade sizes: 24 in (610 mm) driver side · 17 in (430 mm) passenger side
• Connector: Top-Lock push-button
• Quantity: 2 blades — one complete front pair. The rear wiper is a separate blade and is not part of this set.
• Left- and right-hand drive: the same pairing serves both — fit the 24 in blade on the driver's side of your car and the 17 in on the passenger side.

1. Park with the wipers accessible. If your ATTO 3 tucks its wipers low at rest, switch on the wiper service position from the vehicle settings so the arms lift clear of the bonnet edge. Lift the arm away from the glass and let it stand — rest it back only once the new blade is on, so the bare arm never snaps onto the screen.
2. Press the button on the old blade's connector and slide the blade down off the arm, exactly as pictured in the installation photo.
3. Slide the new blade onto the arm until the locking tab clicks into the adapter window. Give it a firm tug — a locked blade does not move.
4. Peel the protective strip off the rubber edge, lower the arm gently onto the glass, and repeat on the other side.
5. Run the washers and a few sweeps. A new pair wipes the screen clean and silent from the first pass.

• Contents: 1 × 24 in front blade, 1 × 17 in front blade
• Type: frameless beam (flat) wiper blades with aerodynamic spoiler
• Connector: Top-Lock, pre-fitted
• Fitment: BYD ATTO 3 / Yuan PLUS front windscreen
• Care: wipe the rubber edge with a damp cloth whenever you wash the car — grit on the edge is what shortens a blade's life. Replace the pair every 6–12 months, or at the first return of streaking and chatter.

Which blade goes on which side?
The long 24-inch blade fits the driver's side and the short 17-inch blade fits the passenger side. That holds for both left-hand-drive and right-hand-drive cars — "driver side" is the only label you need to follow.

Do these fit my ATTO 3's wiper arms directly?
Yes. The blades carry the Top-Lock push-button connector the ATTO 3 uses, pre-fitted out of the pack. They slide onto the arm and click locked — no adapter hunting, no tools, nothing else to buy.

Why replace both blades at once?
Both blades have lived through the same sun, frost and mileage, so both edges are equally worn. Changing only one leaves the old blade streaking across your main field of view and wears the new blade unevenly. A matched pair restores the full swept area in one job.

Is the rear wiper included?
No. This is the front pair — driver and passenger. The ATTO 3's rear blade is a different, shorter blade with its own fitting, and it wears far more slowly than the fronts.

What is the strip along the rubber edge in the photos?
That is the shipping protector for the wiping edge. It keeps the precision-cut rubber pristine in the pack. Fit the blade first, then peel the strip away before you lower the arm — fitting is shown step by step in the photos.

How long will they last?
Plan on 6–12 months of daily driving from a set, depending on climate — harsh sun and frost age rubber fastest. When streaks or noise return, the edge has hardened and it is time for the next pair. Keeping the edge wiped clean at each car wash gets you to the long end of that range.

My old blades judder even though they look fine — will new ones fix it?
Almost certainly yes. Judder and squeak come from rubber that has hardened and taken a set at its parked angle, which the eye cannot judge. Fresh, flexible edges on these beam blades sit flat and glide — the noise and the hopping stop with the swap.

Standard worldwide shipping is $9.90 USD on orders below $29.90 USD. Orders of $29.90 USD or more ship free with standard shipping. Return requests can be submitted within 30 days after delivery — see our Returns & Refunds policy for the full terms.

BYD SPOT is an independent accessories retailer and is not affiliated with, endorsed by, or sponsored by BYD Company Limited. Vehicle names and trademarks are used solely to identify product compatibility.